Difficulty

Difficult

Steps

7

Time Required

                          30 minutes - 1 hour

Sections

1

  • Logic Board
  • 7 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackComputer King Muffin Kinder 7

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Make sure to power off the device before you begin to take apart your device. Not doing so could potentially cause harm.

What you need

Step 1

              Logic Board
  • Use the plastic opening tool help push out the microSD card from the microSD slot.

Use the plastic opening tool help push out the microSD card from the microSD slot.

1024

Step 2

  • Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

Step 3

  • Unscrew the nine 3.0 mm Phillips #00 screws.

Unscrew the nine 3.0 mm Phillips #00 screws.

Step 4

  • The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic

The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic

Step 5

  • Unsolder the 11 red, back, and grey wires connected to the logic board.
  • Tips on how to solder can be found here.

Unsolder the 11 red, back, and grey wires connected to the logic board.

Tips on how to solder can be found here.

Step 6

  • Use the flat end of the spudger to lift the black panels covering the three ribbon cables connected to the logic board.

Use the flat end of the spudger to lift the black panels covering the three ribbon cables connected to the logic board.

Step 7

  • Pull the three ribbon cables out so that they are no longer connected to the logic board.

Pull the three ribbon cables out so that they are no longer connected to the logic board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Katherine

Member since: 01/22/2015

412 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UWT Liner: Group 2                        

                                                  Member of UWT Liner: Group 2 



                    Community                     


                                            4 Members                     


                                            6 Guides authored