Difficulty

Moderate

Steps

7

Time Required

                          5 minutes

Sections

1

  • Display Assembly
  • 7 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackCompaq Presario CQ60-211DX

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Display Assembly
  • Start by making sure the CQ60 is powered down and that the disk drive is empty.
  • Flip the device over and remove the battery.

Start by making sure the CQ60 is powered down and that the disk drive is empty.

Flip the device over and remove the battery.

1024

Step 2

  • Remove the rubber screw covers next to each of the two screen hinges using a metal spudger.
  • Unscrew the screws underneath the rubber cover using the blank Phillips-head screwdriver.

Remove the rubber screw covers next to each of the two screen hinges using a metal spudger.

Unscrew the screws underneath the rubber cover using the blank Phillips-head screwdriver.

Step 3

  • Use the metal spudger to gently pry the plastic faceplate off the rest of the display.

Use the metal spudger to gently pry the plastic faceplate off the rest of the display.

Step 4

  • Unscrew the two screws in the top corners to separate the frame holding the assembly from the plastic of the lid.

Unscrew the two screws in the top corners to separate the frame holding the assembly from the plastic of the lid.

Step 5

  • Disconnect the assembly from the chip located between the hinges by pulling the wires to the right.

Disconnect the assembly from the chip located between the hinges by pulling the wires to the right.

Step 6

  • Pull the frame forward, and then unscrew the three screws on each side.

Pull the frame forward, and then unscrew the three screws on each side.

Step 7

  • Disconnect the ribbon cable on the back of the display by peeling back the tape and then pulling down on the cable.

Disconnect the ribbon cable on the back of the display by peeling back the tape and then pulling down on the cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Garrett Carter

Member since: 09/21/2018

471 Reputation

                                      4 Guides authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team S2-G3, Riccardelli Fall 2018                        

                                                  Member of University of North Texas, Team S2-G3, Riccardelli Fall 2018 



                    UNT-RICCARDELLI-F18S2G3                     


                                            4 Members                     


                                            8 Guides authored

Rashid 007 - Jun 25, 2020

Reply

My laptop model Compaq predario cq61 h

Computer on but display light of computer is running