Comfort Zone Cz6C Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Switch
7 steps

Flags

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

BackComfort Zone CZ6C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Switch

Make sure to unplug the Comfort Zone CZ6C before cutting any wires.
Before replacing your switch, learn how to solder using the How To Solder and Desolder Connections Guide.
Start with the fan on its back. Unscrew the back panel to expose the internal wiring.

Make sure to unplug the Comfort Zone CZ6C before cutting any wires.

Before replacing your switch, learn how to solder using the How To Solder and Desolder Connections Guide.

Start with the fan on its back. Unscrew the back panel to expose the internal wiring.

1024

Step 2

Remove the plastic cover on the switch by pulling it apart from the the back panel.

Remove the plastic cover on the switch by pulling it apart from the the back panel.

Step 3

Use the soldering iron with caution. Don’t touch the tip of the soldering iron to avoid the risk of injury.
This step can be made easier with the help of a partner to hold the wiring while you desolder the connection.
Disconnect the gray power wire from the switch by desoldering the connection.

Use the soldering iron with caution. Don’t touch the tip of the soldering iron to avoid the risk of injury.

This step can be made easier with the help of a partner to hold the wiring while you desolder the connection.

Disconnect the gray power wire from the switch by desoldering the connection.

Step 4

Cut the green and yellow wire as close to the switch connection as possible.

Cut the green and yellow wire as close to the switch connection as possible.

Step 5

Strip the green and yellow wire about two centimeters from where it was just cut.

Strip the green and yellow wire about two centimeters from where it was just cut.

Step 6

Unscrew the switch from the back panel and remove it.

Unscrew the switch from the back panel and remove it.

Step 7

After replacing the switch, resolder the gray power cord, the green wire, and the yellow wire.

After replacing the switch, resolder the gray power cord, the green wire, and the yellow wire.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    James Abundis

Member since: 04/08/2015

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 17-5, Forte Spring 2015                        

                                                  Member of Cal Poly, Team 17-5, Forte Spring 2015 



                    CPSU-FORTE-S15S17G5                     


                                            4 Members                     


                                            5 Guides authored

Michael Drasic - Jan 19, 2022

I need a replacement switch for a Comfort Zone CZ40 heater. Can you help?

Step Trimmer#

Introduction#

What you need#

Team#

Step Trimmer

Introduction

What you need

Team