Comfort Zone Cz6C Power Cable Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Power Cable
5 steps

Flags

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

BackComfort Zone CZ6C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Cable

Make sure to unplug the Comfort Zone CZ6C before cutting any wires.
Before attempting to replace your power cable, learn how to solder using the How To Solder and Desolder Corrections Guide.
Start with the fan on its back. Unscrew the back panel to expose the internal wiring.

Make sure to unplug the Comfort Zone CZ6C before cutting any wires.

Before attempting to replace your power cable, learn how to solder using the How To Solder and Desolder Corrections Guide.

Start with the fan on its back. Unscrew the back panel to expose the internal wiring.

1024

Step 2

Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart.

Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart.

Step 3

Remove the plastic cover on the switch by pulling it apart from the back panel.

Remove the plastic cover on the switch by pulling it apart from the back panel.

Step 4

Use the soldering iron with caution. Don’t touch the tip of the soldering iron to avoid the risk of injury.
This step can be made easier with the help of a partner to hold the wiring while you desolder the connection.
Disconnect the gray power wire from the switch by desoldering the connection.

Use the soldering iron with caution. Don’t touch the tip of the soldering iron to avoid the risk of injury.

This step can be made easier with the help of a partner to hold the wiring while you desolder the connection.

Disconnect the gray power wire from the switch by desoldering the connection.

Step 5

Strip the end of the gray power cord.
Then solder the end of the gray power cord to the switch.

Strip the end of the gray power cord.

Then solder the end of the gray power cord to the switch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Nishanth Dara

Member since: 04/08/2015

141 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 17-5, Forte Spring 2015                        

                                                  Member of Cal Poly, Team 17-5, Forte Spring 2015 



                    CPSU-FORTE-S15S17G5                     


                                            4 Members                     


                                            5 Guides authored

Step Trimmer#

Introduction#

What you need#

Team#

Step Trimmer

Introduction

What you need

Team