Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

2

  • Battery
  • 4 steps
  • Main Power Board
  • 3 steps

Flags

0

  • BackColeman Rechargeable Fluorescent Twin Tube

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Carefully turn the lantern upside down.
  • Remove the three 1.2 mm Phillips #0 screws from the base of the lantern.

Carefully turn the lantern upside down.

Remove the three 1.2 mm Phillips #0 screws from the base of the lantern.

1024

Step 2

  • Carefully pull the bottom of the lantern to remove the base from the device.

Carefully pull the bottom of the lantern to remove the base from the device.

Step 3

  • Gently pull the battery out of the slot and away from the base.
  • The battery may be held into place by adhesive strips.

Gently pull the battery out of the slot and away from the base.

The battery may be held into place by adhesive strips.

Step 4

  • Carefully detach the negative wire from the battery terminal first.
  • Next, detach the positive wire from the battery terminal.

Carefully detach the negative wire from the battery terminal first.

Next, detach the positive wire from the battery terminal.

Step 5

              Main Power Board
  • Remove the single 1.2 mm Phillips #1 screw on the bottom of the lantern.
  • Remove the plastic barrier.

Remove the single 1.2 mm Phillips #1 screw on the bottom of the lantern.

Remove the plastic barrier.

Step 6

  • Unscrew the single 1.2 mm Phillips #1 screw holding the motherboard to the plastic lantern housing.

Unscrew the single 1.2 mm Phillips #1 screw holding the motherboard to the plastic lantern housing.

Step 7

  • Gently grab the main board by the exposed PCB.
  • Pull the main board straight out of the housing.

Gently grab the main board by the exposed PCB.

Pull the main board straight out of the housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Mathew  Merrick

Member since: 09/17/2018

169 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       Washington State, Team S2-G1, Hope Fall 2018                        

                                                  Member of Washington State, Team S2-G1, Hope Fall 2018 



                    WSU-HOPE-F18S2G1                     


                                            4 Members                     


                                            4 Guides authored