Difficulty
Very easy
Steps
8
Time Required
1 minute
Sections
3
- Battery
- 4 steps
- Main Power Board
- 3 steps
- Lantern Power Switch
- 1 step
Flags
0
BackColeman Rechargeable Fluorescent Twin Tube
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Carefully turn the lantern upside down.
- Remove the three 1.2 mm Phillips #0 screws from the base of the lantern.
Carefully turn the lantern upside down.
Remove the three 1.2 mm Phillips #0 screws from the base of the lantern.
1024
Step 2
- Carefully pull the bottom of the lantern to remove the base from the device.
Carefully pull the bottom of the lantern to remove the base from the device.
Step 3
- Gently pull the battery out of the slot and away from the base.
- The battery may be held into place by adhesive strips.
Gently pull the battery out of the slot and away from the base.
The battery may be held into place by adhesive strips.
Step 4
- Carefully detach the negative wire from the battery terminal first.
- Next, detach the positive wire from the battery terminal.
Carefully detach the negative wire from the battery terminal first.
Next, detach the positive wire from the battery terminal.
Step 5
Main Power Board
- Remove the single 1.2 mm Phillips #1 screw on the bottom of the lantern.
- Remove the plastic barrier.
Remove the single 1.2 mm Phillips #1 screw on the bottom of the lantern.
Remove the plastic barrier.
Step 6
- Unscrew the single 1.2 mm Phillips #1 screw holding the motherboard to the plastic lantern housing.
Unscrew the single 1.2 mm Phillips #1 screw holding the motherboard to the plastic lantern housing.
Step 7
- Gently grab the main board by the exposed PCB.
- Pull the main board straight out of the housing.
Gently grab the main board by the exposed PCB.
Pull the main board straight out of the housing.
Step 8
Lantern Power Switch
- Remove the switch by pushing down on the ends while simultaneously pulling it out of the slot.
- When removing the switch, make sure to depress the inner clips when removing from the device. Be careful, do not force the switch from the base of the lantern.
Remove the switch by pushing down on the ends while simultaneously pulling it out of the slot.
When removing the switch, make sure to depress the inner clips when removing from the device. Be careful, do not force the switch from the base of the lantern.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Mathew Merrick
Member since: 09/17/2018
169 Reputation
2 Guides authored
Badges:
2
Team
Washington State, Team S2-G1, Hope Fall 2018
Member of Washington State, Team S2-G1, Hope Fall 2018
WSU-HOPE-F18S2G1
4 Members
4 Guides authored
