Difficulty
Moderate
Steps
4
Time Required
20 minutes
Sections
1
- Controller Circuit Board
- 4 steps
Flags
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackColecoVision
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Controller Circuit Board
- Unplug the controller from the game console.
Unplug the controller from the game console.
1024
Step 2
- Place the controller with the back panel up (buttons down).
- Remove the five 15mm screws on the back with a Phillips #1 screwdriver.
Place the controller with the back panel up (buttons down).
Remove the five 15mm screws on the back with a Phillips #1 screwdriver.
Step 3
- Turn the device around.
- Separate the front panel from the rest of the controller and set aside.
Turn the device around.
Separate the front panel from the rest of the controller and set aside.
Step 4
- Remove the tape and wiring holding the wires in place.
- Carefully lift the circuit board out of the controller.
Remove the tape and wiring holding the wires in place.
Carefully lift the circuit board out of the controller.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Juin Yeh
Member since: 10/17/2018
205 Reputation
2 Guides authored
Badges:
3
Team
UW Tacoma, Team S1-G2, Rose Fall 2018
Member of UW Tacoma, Team S1-G2, Rose Fall 2018
UWT-ROSE-F18S1G2
4 Members
12 Guides authored