Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

3

  • Outer Casing
  • 3 steps
  • Battery
  • 1 step
  • Motherboard
  • 2 steps

Flags

0

  • BackCoby Kyros MID9742

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Casing
  • Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.

Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.

1024

Step 2

  • Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.

Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.

Step 3

  • Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.
  • Note that clicking noises will be heard during this process, the panels are assembled well so it may take some force to separate the two panels.
  • Use caution while prying, do not stick the metal spudger in too far as it may damage internal components

Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.

Note that clicking noises will be heard during this process, the panels are assembled well so it may take some force to separate the two panels.

Use caution while prying, do not stick the metal spudger in too far as it may damage internal components

Step 4

              Battery
  • Use a soldering iron to remove the connection between the red wire first then proceed to the black wire.

Use a soldering iron to remove the connection between the red wire first then proceed to the black wire.

Step 5

              Motherboard
  • Use the PH00 screwdriver to remove the six 0.25 cm screws circled in the image.

Use the PH00 screwdriver to remove the six 0.25 cm screws circled in the image.

Step 6

  • Remove the ribbon cables by gently lifting the black tabs and pulling out the cable.
  • This will allow the user to lift and remove the motherboard from the tablet.

Remove the ribbon cables by gently lifting the black tabs and pulling out the cable.

This will allow the user to lift and remove the motherboard from the tablet.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Ian Swett

Member since: 03/11/2015

597 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Colorado Springs, Team 5-3, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 5-3, Panko Spring 2015 



                    UCCS-PANKO-S15S5G3                     


                                            3 Members                     


                                            12 Guides authored