Coby Kyros Mid9742 Camera Module Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

2

• Outer Casing
• 3 steps
• Camera Module
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackCoby Kyros MID9742

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Outer Casing               

• Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.

Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.

1024

Step 2

• Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.

Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.

Step 3

• Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.
• Note that clicking noises will be heard during this process, the panels are assembled well so it may take some force to separate the two panels.
• Use caution while prying, do not stick the metal spudger in too far as it may damage internal components

Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.

Note that clicking noises will be heard during this process, the panels are assembled well so it may take some force to separate the two panels.

Use caution while prying, do not stick the metal spudger in too far as it may damage internal components

Step 4

              Camera Module               

• Remove the two ribbon cables attached to the logic board.

Remove the two ribbon cables attached to the logic board.

Step 5

• Remove the tape covering the ribbon cables and remove the camera module.

Remove the tape covering the ribbon cables and remove the camera module.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Jake                     

Member since: 03/11/2015

158 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Colorado Springs, Team 5-3, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 5-3, Panko Spring 2015 



                    UCCS-PANKO-S15S5G3                     


                                            3 Members                     


                                            12 Guides authored