Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes

Sections

2

  • The bottom portion of the DVD player
  • 3 steps
  • Circuit Board for Buttons
  • 2 steps

Flags

0

  • BackCoby DVD209

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              The bottom portion of the DVD player
  • Press the eject button to view the laser inside.
  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

Press the eject button to view the laser inside.

Using the blue plastic tool and the tweezers, remove the ribbon cable.

1024

Step 2

  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.
  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.
  • Pry the top of the device open from the right side where the buttons are located.

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

Pry the top of the device open from the right side where the buttons are located.

Step 3

  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.
  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

Step 4

              Circuit Board for Buttons
  • Take the top portion of the DVD player and orient the device as shown in the first picture.
  • Remove the four 0.2" screws circled in red.

Take the top portion of the DVD player and orient the device as shown in the first picture.

Remove the four 0.2" screws circled in red.

Step 5

  • Losen the screw circled in red.
  • The screw will not come out of the plastic knob.
  • Turn the plastic knob 90 degrees to the right so that the cable comes out freely.

Losen the screw circled in red.

The screw will not come out of the plastic knob.

Turn the plastic knob 90 degrees to the right so that the cable comes out freely.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Yufay Chow

Member since: 01/23/2012

92 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team 10-36, Amido Winter 2012                        

                                                  Member of Cal Poly, Team 10-36, Amido Winter 2012 



                    CPSU-AMIDO-W12S10G36                     


                                            4 Members                     


                                            7 Guides authored