Difficulty
Very easy
Steps
3
Time Required
5 - 10 minutes
Sections
2
- Outer Casing
- 2 steps
- 3-Pin Power Cable
- 1 step
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackCoby DVD-R11000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Outer Casing
- Remove the four 1cm screws, two on each side, of the DVD player with the Phillips #1 screwdriver.
- Remove the five 1cm screws on the back of the DVD player with the Phillips #1 screwdriver.
- It is not required to remove the other seven screws in the middle between the I/O ports.
Remove the four 1cm screws, two on each side, of the DVD player with the Phillips #1 screwdriver.
Remove the five 1cm screws on the back of the DVD player with the Phillips #1 screwdriver.
It is not required to remove the other seven screws in the middle between the I/O ports.
1024
Step 2
- Position the DVD player so that the back is facing you
- Grab underneath the sides of the DVD player and lift the front of it upwards.
- Carefully pull the top of the casing off
Position the DVD player so that the back is facing you
Grab underneath the sides of the DVD player and lift the front of it upwards.
Carefully pull the top of the casing off
Step 3
3-Pin Power Cable
- Gently pinch the 3-pin white adapter of the wire connecting the power cord to the circuit board.
- Remove the wire from the circuit board.
Gently pinch the 3-pin white adapter of the wire connecting the power cord to the circuit board.
Remove the wire from the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Andrew
Member since: 10/22/2014
501 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
UMass Dartmouth, Team 1-6, Shastany Fall 2014
Member of UMass Dartmouth, Team 1-6, Shastany Fall 2014
UMASSD-SHASTANY-F14S1G6
4 Members
5 Guides authored