Difficulty
Moderate
Steps
7
Time Required
7 - 10 minutes
Sections
3
- Windshield Bracket Mount
- 4 steps
- Buttonboard
- 2 steps
- Buttons
- 1 step
Flags
0
BackCobra SPX 5300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Windshield Bracket Mount
- Remove the four 9.5 mm Phillips #0 screws from the back of the device.
Remove the four 9.5 mm Phillips #0 screws from the back of the device.
1024
Step 2
- Pull the black plastic back case off of the device.
Pull the black plastic back case off of the device.
Step 3
- Lift up the motherboard and lay it flat next to the device.
- Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.
Lift up the motherboard and lay it flat next to the device.
Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.
Step 4
- Remove the windshield bracket mount.
Remove the windshield bracket mount.
Step 5
Buttonboard
- Remove the four 4.8 mm Phillips #00 screws from the buttonboard.
Remove the four 4.8 mm Phillips #00 screws from the buttonboard.
Step 6
- Lift buttonboard to expose silver button plate.
Lift buttonboard to expose silver button plate.
Step 7
Buttons
- Remove the silver button plate by gripping one of the corners and pulling up.
Remove the silver button plate by gripping one of the corners and pulling up.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Fanny Auad
Member since: 09/25/2015
265 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
University of Tampa, Team 1-2, Whiteside Fall 2015
Member of University of Tampa, Team 1-2, Whiteside Fall 2015
UT-WHITESIDE-F15S1G2
4 Members
5 Guides authored
