Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
2
- Windshield Bracket Mount
- 4 steps
- Audio Dial
- 2 steps
Flags
0
BackCobra SPX 5300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Windshield Bracket Mount
- Remove the four 9.5 mm Phillips #0 screws from the back of the device.
Remove the four 9.5 mm Phillips #0 screws from the back of the device.
1024
Step 2
- Pull the black plastic back case off of the device.
Pull the black plastic back case off of the device.
Step 3
- Lift up the motherboard and lay it flat next to the device.
- Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.
Lift up the motherboard and lay it flat next to the device.
Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.
Step 4
- Remove the windshield bracket mount.
Remove the windshield bracket mount.
Step 5
Audio Dial
- Remove the one 4.8 mm Phillips #00 screw from the center of the audio dial.
Remove the one 4.8 mm Phillips #00 screw from the center of the audio dial.
Step 6
- Remove audio dial.
Remove audio dial.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Samantha Delle
Member since: 09/25/2015
101 Reputation
1 Guide authored
Badges:
3
Team
University of Tampa, Team 1-2, Whiteside Fall 2015
Member of University of Tampa, Team 1-2, Whiteside Fall 2015
UT-WHITESIDE-F15S1G2
4 Members
5 Guides authored
