No matter what you do, you can’t get your Cobra 29 LTD Classic to turn on.
Before tearing your Cobra 29 LTD Classic apart, check the volume knob to make sure it is properly connected and in the ‘on’ position. Check out the replacement guide for the Volume Knob.
Check to make sure your power cable is connected properly to the power source, usually the vehicle’s battery. Check out the replacement guide for the Power Cable.
Check that the inline fuse is connected to the red power cable. If the fuse is broken it must be replaced. Check out the replacement guide for the Fuse.
The Cobra 29 LTD Classic is not transmitting or receiving any signals after trying several channels.
Make sure that your antenna has been properly tuned before you try transmitting with your radio. If you try to transmit signals and your antenna is not tuned you may damage your Cobra 29 LTD Classic.
The Cobra 29 LTD classic has two transmitting modes. The CB mode which is the mode for transmitting and receiving. The PA mode which is used for talking through an external speaker on your vehicle. This mode does not transmit. There is a switch on the front of the Cobra 29 LTD Classic to switch between the PA mode and CB mode. Make sure the switch is in the CB position.
Check that the channel is the one you are trying to transmit and receive on.
The squelch knob is like a gate for incoming signals. when the knob is turned all the way clockwise it closes the gate for all incoming signals except for the very strong ones. When the knob is all the way counterclockwise it opens the gate all the way up to let in all signals and white noise. For proper operation the squelch should be adjusted so that you have the gate open as wide as you can without hearing the white noise. So start with your knob all the way counterclockwise and turn slowly in the clockwise direction until the white noise stops. That should be the operating position.
Please see our replacement guide for the Microphone.
You can hear others through your radio, but others can’t hear you
Turn the dynamike knob up past 75%, it can be found on the front of the device.
Check that the channel is on the correct channel and that when you transmit a signal, make sure that receive a signal is on.
Make sure the mic is connected to the Cobra 29 LTD Classic properly. If that doesn’t work, try a different mic to ensure that the mic isn’t faulty. Check out the replacement guide for the Microphone.
There is a large amount of static, making it difficult for you to hear and understand what is being transmitted/received on the Cobra 29 LTD Classic.
When the volume knob is set at the maximum level, it starts to get distorted, turn the volume knob down to 75% to get a clearer sound.
Your Public Address speaker is not working after checking the volume.
The PA (Public Address) speaker must be connected to the PA.SP port on the back of the Cobra 29 LTD Classic.
Turn the Dynamike knob up to 75%.
