Difficulty
Moderate
Steps
7
Time Required
20 - 25 minutes
Sections
1
- Camera
- 7 steps
Flags
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackClickN Kids Tablet
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Camera
- Start on the side with the camera
- Insert a plastic opening tool into the space between the screen and the back side.
- The screen side is black, the back side is colored
Start on the side with the camera
Insert a plastic opening tool into the space between the screen and the back side.
The screen side is black, the back side is colored
1024
Step 2
- Press the plastic opening tool in until you hear a “click” and that part of the tablet opens.
- Press and slide the plastic opening tool around all sides of the tablet until all sides pop off.
- The corners can be tricky. Make sure to separate the pieces all the way around the tablet before attempting to open it.
Press the plastic opening tool in until you hear a “click” and that part of the tablet opens.
Press and slide the plastic opening tool around all sides of the tablet until all sides pop off.
The corners can be tricky. Make sure to separate the pieces all the way around the tablet before attempting to open it.
Step 3
- Lift the detached screen from the camera side until you can see the inside of the tablet.
- Don’t open too fast, or you might damage the ribbons cables.
Lift the detached screen from the camera side until you can see the inside of the tablet.
Don’t open too fast, or you might damage the ribbons cables.
Step 4
- Be careful not to damage any wires or ribbon cables during this step.
- There are two ribbon cables to remove during this step. Each is connected to a base on the motherboard.
- There is a black tab behind the long ribbon cable. Lift up the black tab.
- For the ribbon cable in the back, pull the black tabs on the side out.
- Detach the ribbon cables connecting the screen to the motherboard.
- Remove any tape that is holding down the ribbon cables. Set it aside.
Be careful not to damage any wires or ribbon cables during this step.
There are two ribbon cables to remove during this step. Each is connected to a base on the motherboard.
There is a black tab behind the long ribbon cable. Lift up the black tab.
For the ribbon cable in the back, pull the black tabs on the side out.
Detach the ribbon cables connecting the screen to the motherboard.
Remove any tape that is holding down the ribbon cables. Set it aside.
Step 5
- Pull off the tape that holds the ribbon cable to the battery.
Pull off the tape that holds the ribbon cable to the battery.
Step 6
- Be careful not to damage the wires or ribbon cables.
- Pull out the two black ends of the base on the motherboard.
- Slide out the camera’s ribbon cable once the ends are loosened.
Be careful not to damage the wires or ribbon cables.
Pull out the two black ends of the base on the motherboard.
Slide out the camera’s ribbon cable once the ends are loosened.
Step 7
- Use a plastic opening tool to pry the camera out of its place.
Use a plastic opening tool to pry the camera out of its place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Kevin Finney
Member since: 03/22/2015
553 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
Baylor, Team 4-4, Williams Spring 2015
Member of Baylor, Team 4-4, Williams Spring 2015
BU-WILLIAMS-S15S4G4
3 Members
8 Guides authored
