Difficulty

Moderate

Steps

8

Time Required

                          10 - 30 minutes

Sections

3

  • Safety Precautions
  • 2 steps
  • Belt Guard
  • 4 steps
  • Rake Belt
  • 2 steps

Flags

0

  • BackClassen Over Seeder TS-20 (2012)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions
  • Before you begin, ensure that the machine is powered down and cool to the touch.
  • Disconnect the spark plug to prevent the engine from accidentally starting up during service:
  • Grab the plastic housing at the end of the spark plug wire.
  • Pull firmly to disconnect the wire from the spark plug.

Before you begin, ensure that the machine is powered down and cool to the touch.

Disconnect the spark plug to prevent the engine from accidentally starting up during service:

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

1024

Step 2

  • To prevent the over seeder from rolling during service, place wheel chocks behind a rear wheel.

To prevent the over seeder from rolling during service, place wheel chocks behind a rear wheel.

Step 3

              Tilt the over seeder
  • Push down on the main handle to tilt the over seeder back on its rear wheels.
  • Place some weights on the handle, or tie the handle down, to prevent the machine from falling forward.

Push down on the main handle to tilt the over seeder back on its rear wheels.

Place some weights on the handle, or tie the handle down, to prevent the machine from falling forward.

Step 4

  • Place a wheel chock in front of a rear tire to keep the machine in place.

Place a wheel chock in front of a rear tire to keep the machine in place.

Step 5

              Unscrew the belt guard
  • Remove the four lock nuts securing the belt guard:
  • Two 1/2" lock nuts
  • Two 7/16" lock nuts
  • These lock nuts are recessed and require a socket extension to access.
  • Use box wrenches to hold the corresponding bolts in place as you loosen and remove the nuts.

Remove the four lock nuts securing the belt guard:

Two 1/2" lock nuts

Two 7/16" lock nuts

These lock nuts are recessed and require a socket extension to access.

Use box wrenches to hold the corresponding bolts in place as you loosen and remove the nuts.

Step 6

              Remove the belt guard
  • Remove the belt guard.

Remove the belt guard.

Step 7

              Rake Belt
  • Use your fingers to pry the belt off the drive pulley.
  • If you are having trouble, make sure that the machine is not resting on the bail bar up by the handlebars, which tightens the idler pulley.

Use your fingers to pry the belt off the drive pulley.

If you are having trouble, make sure that the machine is not resting on the bail bar up by the handlebars, which tightens the idler pulley.

Step 8

  • Squeeze the belt and unhook it from the engine pulley.
  • Remove the rake belt.

Squeeze the belt and unhook it from the engine pulley.

Remove the rake belt.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Arthur Shi

Member since: 01/03/2018

211,865 Reputation

                                      442 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored