Difficulty
Moderate
Steps
10
Time Required
10 - 15 minutes
Sections
1
- Watch Face Hands
- 10 steps
Flags
0
BackWatch
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Watch Face Hands
- Locate the notch under the back cap of the watch. Wedge the jimmy into the notch, and pry off the back.
Locate the notch under the back cap of the watch. Wedge the jimmy into the notch, and pry off the back.
1024
Step 2
- Remove the circular plastic cover from inside the watch.
Remove the circular plastic cover from inside the watch.
Step 3
- Remove the crown stalk by placing the needle in the release notch. This will release stalk and allow it to slide out.
Remove the crown stalk by placing the needle in the release notch. This will release stalk and allow it to slide out.
Step 4
- Turn watch on its side and let the watch face fall out.
Turn watch on its side and let the watch face fall out.
Step 5
- Gently pry the watch hands off of the face of the watch with the jimmy and tweezers.
Gently pry the watch hands off of the face of the watch with the jimmy and tweezers.
Step 6
- Use the tweezers to replace the hands of the watch.
- First, place the hour hand on the watch face stem, followed by the minute hand, and the second hand.
Use the tweezers to replace the hands of the watch.
First, place the hour hand on the watch face stem, followed by the minute hand, and the second hand.
Step 7
- Place the watch face downwards in its case.
- Make sure the crown stalk holes are aligned.
Place the watch face downwards in its case.
Make sure the crown stalk holes are aligned.
Step 8
- Insert the crown stalk into the crown stalk holes.
Insert the crown stalk into the crown stalk holes.
Step 9
- Place the plastic cover back in its original place.
- Use the crown notch for guidance in alignment.
Place the plastic cover back in its original place.
Use the crown notch for guidance in alignment.
Step 10
- Press the back cover on the watch using hands or clamp, until it pops into place.
Press the back cover on the watch using hands or clamp, until it pops into place.
Now that the watch hands are repaired, the watch can be reset manually so that the it can keep the correct time.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Justin Sidwell
Member since: 02/28/2017
111 Reputation
1 Guide authored
Badges:
3
Team
University of Memphis, Team S4-G5, Baddour Spring 2017
Member of University of Memphis, Team S4-G5, Baddour Spring 2017
UM-BADDOUR-S17S4G5
3 Members
1 Guide authored
