Difficulty

Moderate

Steps

12

Time Required

                          20 minutes

Sections

2

  • Chassis
  • 9 steps
  • Speaker
  • 3 steps

Flags

0

  • BackChumby One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Chassis
  • Remove 4 self-adhesive plastic dots covering the screw holes.

Remove 4 self-adhesive plastic dots covering the screw holes.

1024

Step 2

  • Remove the four 2mm screws with a Phillips screwdriver.

Remove the four 2mm screws with a Phillips screwdriver.

Step 3

  • Remove the back and bottom cover.

Remove the back and bottom cover.

Step 4

  • Disconnect the battery connector from the motherboard with a plastic opening tool.

Disconnect the battery connector from the motherboard with a plastic opening tool.

Step 5

  • Disconnect the microphone connector from the motherboard with a plastic opening tool.

Disconnect the microphone connector from the motherboard with a plastic opening tool.

Step 6

  • Remove the display ribbon cable from its socket with a plastic opening tool.

Remove the display ribbon cable from its socket with a plastic opening tool.

Step 7

  • Remove the volume knob from the side of the Chumby One with a plastic opening tool.

Remove the volume knob from the side of the Chumby One with a plastic opening tool.

Step 8

  • Remove the four 6mm screws using a PH000 bit on the inner chassis.

Remove the four 6mm screws using a PH000 bit on the inner chassis.

Step 9

  • Remove the inner components from the outer shell.

Remove the inner components from the outer shell.

Step 10

              Speaker
  • Remove the speaker wire connector from the motherboard.

Remove the speaker wire connector from the motherboard.

Step 11

  • Remove the four 5mm screws on the speaker base with a Phillips PH00 screwdriver bit.

Remove the four 5mm screws on the speaker base with a Phillips PH00 screwdriver bit.

Step 12

  • Remove the speaker.

Remove the speaker.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jordan Houchins

Member since: 03/27/2017

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S3-G3, Baechle Spring 2017                        

                                                  Member of IUPUI, Team S3-G3, Baechle Spring 2017 



                    IUPUI-BAECHLE-S17S3G3                     


                                            4 Members                     


                                            4 Guides authored