Difficulty

Moderate

Steps

13

Time Required

                          30 - 45 minutes

Sections

3

  • Power Cord
  • 5 steps
  • Power Cord
  • 5 steps
  • Motherboard
  • 3 steps

Flags

2

Missed a Step

Oops! This guide is currently missing some important steps.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackCHI Spin N Curl Rotating Curler

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Cord
  • Use a metal spudger to pry off the silver, shiny trim.

Use a metal spudger to pry off the silver, shiny trim.

1024

Step 2

  • Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

Step 3

  • Use a 2 mm flathead to remove the two screws.

Use a 2 mm flathead to remove the two screws.

Step 4

  • Use a metal spudger to pry open the seams of the device.

Use a metal spudger to pry open the seams of the device.

Step 5

  • Toward the bottom of the device, grab the swivel power cord.
  • Gently pull the power cord to detach it from the CHI Spin N Curl
  • Replace the faulty cord when the original cord has been removed.

Toward the bottom of the device, grab the swivel power cord.

Gently pull the power cord to detach it from the CHI Spin N Curl

Replace the faulty cord when the original cord has been removed.

Step 6

              Power Cord

Step 7

Step 8

Step 9

Step 10

Step 11

              Motherboard
  • Use a Phillips #00 screwdriver to remove the screws holding the barrel in.

Use a Phillips #00 screwdriver to remove the screws holding the barrel in.

Step 12

  • Remove the screws using Phillips #00 screwdriver and take off the components.
  • Once all screws are removed, take out the barrel accessing the motherboard underneath.

Remove the screws using Phillips #00 screwdriver and take off the components.

Once all screws are removed, take out the barrel accessing the motherboard underneath.

Step 13

  • Using metal spudger, lift and remove the motherboard and disconnect the top components.

Using metal spudger, lift and remove the motherboard and disconnect the top components.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Annalise White

Member since: 10/26/2022

512 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UMass Dartmouth, Team 2-7, Petersen Fall 2022                        

                                                  Member of UMass Dartmouth, Team 2-7, Petersen Fall 2022 



                    UMASSD-PETERSEN-F22S2G7                     


                                            3 Members                     


                                            6 Guides authored