Chef S Choice M115 Power Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Case
4 steps
Power Switch
3 steps

Flags

BackChef’s Choice M115
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Case

Remove the two rubber feet on the motor side of the device.
Remove the five Phillips screws from the bottom of the case.
These screws are recessed deep in the device, so a long, thin screwdriver is required.

Remove the two rubber feet on the motor side of the device.

Remove the five Phillips screws from the bottom of the case.

These screws are recessed deep in the device, so a long, thin screwdriver is required.

1024

Step 2

Remove the two hex-cap screws on the bottom using a pair of pliers.

Remove the two hex-cap screws on the bottom using a pair of pliers.

Step 3

Carefully flip the device right-side-up while grasping the top and bottom pieces.
The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Carefully flip the device right-side-up while grasping the top and bottom pieces.

The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Step 4

Remove the sharpener guard by gently pulling up on it.
If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Remove the sharpener guard by gently pulling up on it.

If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Step 5

              Power Switch

Carefully lift the entire motor assembly out of the case.

Carefully lift the entire motor assembly out of the case.

Step 6

Using a screw driver, unclip the edges of the switch by pushing them inwards and nudging the switch out of the plastic casing. You will hear a click when the edges unhook from the casing.

Using a screw driver, unclip the edges of the switch by pushing them inwards and nudging the switch out of the plastic casing. You will hear a click when the edges unhook from the casing.

Step 7

Remove the spade connectors from the switch by pulling only on the connector, not the wire.
This may require a fair bit of force. Use caution to not damage the device, yourself, or your surroundings.

Remove the spade connectors from the switch by pulling only on the connector, not the wire.

This may require a fair bit of force. Use caution to not damage the device, yourself, or your surroundings.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Hatontola malawo

Member since: 09/17/2015

147 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 3-3, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-3, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G3                     


                                            5 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team