Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

2

  • Case
  • 4 steps
  • Power Cord
  • 3 steps

Flags

0

  • BackChef’s Choice M115

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Remove the two rubber feet on the motor side of the device.
  • Remove the five Phillips screws from the bottom of the case.
  • These screws are recessed deep in the device, so a long, thin screwdriver is required.

Remove the two rubber feet on the motor side of the device.

Remove the five Phillips screws from the bottom of the case.

These screws are recessed deep in the device, so a long, thin screwdriver is required.

1024

Step 2

  • Remove the two hex-cap screws on the bottom using a pair of pliers.

Remove the two hex-cap screws on the bottom using a pair of pliers.

Step 3

  • Carefully flip the device right-side-up while grasping the top and bottom pieces.
  • The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Carefully flip the device right-side-up while grasping the top and bottom pieces.

The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Step 4

  • Remove the sharpener guard by gently pulling up on it.
  • If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Remove the sharpener guard by gently pulling up on it.

If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Step 5

              Power Cord
  • Carefully lift the entire motor assembly out of the case.

Carefully lift the entire motor assembly out of the case.

Step 6

  • Remove the spade connectors from the switch by pulling only on the connector, not the wire.
  • These should come off without tools, but will require a fair bit of force. Mark each wire with tape if you are unsure of the wiring layout of the device.

Remove the spade connectors from the switch by pulling only on the connector, not the wire.

These should come off without tools, but will require a fair bit of force. Mark each wire with tape if you are unsure of the wiring layout of the device.

Step 7

  • Disconnect the spade connector on the motor by pulling only on the connector, not the cord.

Disconnect the spade connector on the motor by pulling only on the connector, not the cord.

To reassemble your device, follow these instructions in reverse order. Take care to ensure the power connections are connected back to their original location.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Zachary Grounds

Member since: 09/17/2015

580 Reputation

                                      3 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       IUPUI, Team 3-3, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-3, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G3                     


                                            5 Members                     


                                            12 Guides authored