Chef S Choice M115 Linkage Pins Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes            

Sections

2

• Case
• 4 steps
• Grinding Disc Linkage Pins
• 2 steps

Flags

0

• BackChef’s Choice M115

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Case               

• Remove the two rubber feet on the motor side of the device.
• Remove the five Phillips screws from the bottom of the case.
• These screws are recessed deep in the device, so a long, thin screwdriver is required.

Remove the two rubber feet on the motor side of the device.

Remove the five Phillips screws from the bottom of the case.

These screws are recessed deep in the device, so a long, thin screwdriver is required.

1024

Step 2

• Remove the two hex-cap screws on the bottom using a pair of pliers.

Remove the two hex-cap screws on the bottom using a pair of pliers.

Step 3

• Carefully flip the device right-side-up while grasping the top and bottom pieces.
• The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Carefully flip the device right-side-up while grasping the top and bottom pieces.

The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

Step 4

• Remove the sharpener guard by gently pulling up on it.
• If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Remove the sharpener guard by gently pulling up on it.

If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Step 5

              Grinding Disc Linkage Pins               

• Remove the motor and shaft assembly from the bottom of the case housing.

Remove the motor and shaft assembly from the bottom of the case housing.

Step 6

• Use a screwdriver to push the pin out of the rod.
• Use pliers to pull the pin the rest of the way out.

Use a screwdriver to push the pin out of the rod.

Use pliers to pull the pin the rest of the way out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    James Herin                     

Member since: 10/27/2015

128 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       IUPUI, Team 3-3, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-3, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G3                     


                                            5 Members                     


                                            12 Guides authored