Cen Tech Seven Function Digital Multimeter Dial Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes            

Sections

2

• Mainboard
• 5 steps
• Dial
• 2 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

• BackCen-Tech Digital Multimeter

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Position Device               

• Place the meter face down, and the back panel and screws can be seen.

Place the meter face down, and the back panel and screws can be seen.

1024

Step 2

              Remove Back Panel Screws               

• Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

Step 3

              Remove Back Panel               

• Remove the back panel of the device by lifting upward.
• Remove the battery from the meter before continuing.

Remove the back panel of the device by lifting upward.

Remove the battery from the meter before continuing.

Step 4

              Unscrew Motherboard               

• Remove the four 7mm Phillips screws holding the circuit board in place.

Remove the four 7mm Phillips screws holding the circuit board in place.

Step 5

              Remove Motherboard               

• Gently lift the circuit board away from the device casing.
• Remove the battery after removing the back cover to reduce the chances of short-circuiting the circuit board.

Gently lift the circuit board away from the device casing.

Remove the battery after removing the back cover to reduce the chances of short-circuiting the circuit board.

Step 6

              Locate Dial               

• The dial is located in the central part of the device.

The dial is located in the central part of the device.

Step 7

              Remove Dial               

• Carefully remove dial from device by lifting upward.
• Clean existing dial or replace if necessary.
• Take care not to lose the small ball bearings.

Carefully remove dial from device by lifting upward.

Clean existing dial or replace if necessary.

Take care not to lose the small ball bearings.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Anna Kihm                     

Member since: 10/13/2014

918 Reputation

                                      5 Guides authored                  



                       Badges:
                       23







                                                        +20 more badges                           

Team

                       Clemson, Team 2-4, Benson Fall 2014                        

                                                  Member of Clemson, Team 2-4, Benson Fall 2014 



                    CLEM-BENSON-F14S2G4                     


                                            4 Members                     


                                            6 Guides authored