Casio G Zone Commando 4G Lte Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Motherboard
7 steps

Flags

BackCasio G’zOne Commando 4G LTE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Motherboard

First, you are going to want to take out the two front screws from the device.
The screws are 4mm in length and require a Y0 bit to remove

First, you are going to want to take out the two front screws from the device.

The screws are 4mm in length and require a Y0 bit to remove

1024

Step 2

Using the same screw head, remove the back four screws from the device.

Using the same screw head, remove the back four screws from the device.

Step 3

You should have taken out six screws (two from the front, four from the back). Once you do this, you will have to separate the front and back casing of the phone using a spudger or pry tool.

You should have taken out six screws (two from the front, four from the back). Once you do this, you will have to separate the front and back casing of the phone using a spudger or pry tool.

Step 4

Now, you have six more screws to unscrew (three on each side). They are all the same size but smaller than the first six we took off.
These screws are 4mm in length and require a PH00 tip to remove.

Now, you have six more screws to unscrew (three on each side). They are all the same size but smaller than the first six we took off.

These screws are 4mm in length and require a PH00 tip to remove.

Step 5

Once you unscrew all six screws, you can easily separate the plastic shell with your hands.

Once you unscrew all six screws, you can easily separate the plastic shell with your hands.

Step 6

Again, there are six more (and even smaller) screws to take out. Additionally, you have to disconnect a small wire plugged into the motherboard.
These screws are 2mm in length and require a PH000 tip to remove.

Again, there are six more (and even smaller) screws to take out. Additionally, you have to disconnect a small wire plugged into the motherboard.

These screws are 2mm in length and require a PH000 tip to remove.

Step 7

After removing the screws carefully separate the motherboard from the shell with the spudger.

After removing the screws carefully separate the motherboard from the shell with the spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors

                    Daniel Keenan

Member since: 10/28/2015

374 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 1-9, Miles Fall 2015                        

                                                  Member of UMass Dartmouth, Team 1-9, Miles Fall 2015 



                    UMASSD-MILES-F15S1G9                     


                                            3 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team