Difficulty
Moderate
Steps
7
Time Required
7 minutes
Sections
3
- Back Plate
- 2 steps
- Battery
- 1 step
- Motherboard and Screen
- 4 steps
Flags
0
BackCasio FX-115MS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Plate
- Remove the 6 screws, which are 5mm long, using a PH1 screwdriver.
Remove the 6 screws, which are 5mm long, using a PH1 screwdriver.
1024
Step 2
- Use plastic spudger to separate backplate from the front-plate. Place the flat end of the spudger in the seam between the front and back, near one end of the calculator. Then slide the spudger towards the calculator’s center. The two sides will pop free from each other as you go through it with the spudger.
Use plastic spudger to separate backplate from the front-plate. Place the flat end of the spudger in the seam between the front and back, near one end of the calculator. Then slide the spudger towards the calculator’s center. The two sides will pop free from each other as you go through it with the spudger.
Step 3
Battery
- Using the pointed end of the nylon spudger, carefully pry an edge of the battery, and lift the battery from its socket.
Using the pointed end of the nylon spudger, carefully pry an edge of the battery, and lift the battery from its socket.
Step 4
Motherboard and Screen
- Using the plastic spudger, carefully pry the battery terminals from the front plate. If the plastic spudger is too weak for prying out the terminals, use the small metal spudger.By Carefully bending and/or prying the little teeth on the terminals upwards you can easily remove them.
Using the plastic spudger, carefully pry the battery terminals from the front plate. If the plastic spudger is too weak for prying out the terminals, use the small metal spudger.By Carefully bending and/or prying the little teeth on the terminals upwards you can easily remove them.
Step 5
- Using the small metal spudger. Carefully pry around the edge of the solar panel until it becomes loose. Then simply pull it from its socket using your hands.
Using the small metal spudger. Carefully pry around the edge of the solar panel until it becomes loose. Then simply pull it from its socket using your hands.
Step 6
- Using a PH0 phillips screwdriver, unscrew the four, 4mm, pan head screws from the motherboard.
Using a PH0 phillips screwdriver, unscrew the four, 4mm, pan head screws from the motherboard.
Step 7
- Carefully lift the motherboard, screen, solar panel, and battery terminal combination from the front plate. Start from the motherboard and lift at an angle toward the solar panel.
Carefully lift the motherboard, screen, solar panel, and battery terminal combination from the front plate. Start from the motherboard and lift at an angle toward the solar panel.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 3 other contributors
Lindsey Griffin
Member since: 10/04/2016
424 Reputation
3 Guides authored
Badges:
15
+12 more badges
Team
USF Tampa, Team 2-2, Nance Fall 2016
Member of USF Tampa, Team 2-2, Nance Fall 2016
USFT-NANCE-F16S2G2
4 Members
10 Guides authored
Ahmad Alsabbagh - Apr 8, 2017
Reply
where can i find an lcd for this exact calculator?