Casdon Dyson Ball On Off Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Battery
2 steps
On/Off Switch
5 steps

Flags

BackCasdon Dyson Ball
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Remove one 9.2mm (0.36 in) screw using the PH00 screwdriver.
Remove the battery cover by pulling it away from the vacuum once the 9.2mm (0.36 in) screw is removed.

Remove one 9.2mm (0.36 in) screw using the PH00 screwdriver.

Remove the battery cover by pulling it away from the vacuum once the 9.2mm (0.36 in) screw is removed.

1024

Step 2

Remove batteries from the vacuum by pulling them out and away from the vacuum.

Remove batteries from the vacuum by pulling them out and away from the vacuum.

Step 3

              On/Off Switch

Remove four 9.2mm (0.32 in) screws from the back of the vacuum using the PH00 screwdriver.

Remove four 9.2mm (0.32 in) screws from the back of the vacuum using the PH00 screwdriver.

Step 4

Remove the cover to the on/off switch by pulling up on the cover from the front of the vacuum.

Remove the cover to the on/off switch by pulling up on the cover from the front of the vacuum.

Step 5

Cut the two wires connected to the on/off switch using a set of wire cutters.

Cut the two wires connected to the on/off switch using a set of wire cutters.

Step 6

Remove the two 9.2mm (0.32 in) screws which hold the on/off switch to the vacuum using the PH00 screwdriver.

Remove the two 9.2mm (0.32 in) screws which hold the on/off switch to the vacuum using the PH00 screwdriver.

Step 7

Remove the on/off switch by pulling it away from the vacuum with your fingers.
Replace the faulty on/off switch with the new on/off switch.
Solder the new on/off switch’s wires to the vacuum’s wires using a soldering station.

Remove the on/off switch by pulling it away from the vacuum with your fingers.

Replace the faulty on/off switch with the new on/off switch.

Solder the new on/off switch’s wires to the vacuum’s wires using a soldering station.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Seldon Price

Member since: 11/07/2017

612 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       IUPUI, Team S3-G5, Harley Fall 2017                        

                                                  Member of IUPUI, Team S3-G5, Harley Fall 2017 



                    IUPUI-HARLEY-F17S3G5                     


                                            3 Members                     


                                            5 Guides authored

debbyh1024 - Feb 19, 2019

Great instructions but where can you purchase the on of switch and what is the part number?

Introduction#

What you need#

Team#

Introduction

What you need

Team