Carrera Mario Copter Controller Circuit Board Replacement Repair Guide

Difficulty

Moderate

Steps

3

Time Required

                          7 minutes            

Sections

1

• Controller Circuit Board
• 3 steps

Flags

0

• BackCarrera Mario Copter

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Controller Circuit Board               

• Flip the controller over so the underside would face up
• Remove four of 7.1mm screws with a JIS #1 screwdriver
• Remove two 4.0mm screws located on the handle with the JIS #1screwdriver.
• Remove two 7.1 mm screws on the small area that stick out from the surface with the JIS #1 screwdriver
• Use an extension with the JIS #1 screwdriver in order to get to the screws with yellow marks because they locate deep inside the holes.

Flip the controller over so the underside would face up

Remove four of 7.1mm screws with a JIS #1 screwdriver

Remove two 4.0mm screws located on the handle with the JIS #1screwdriver.

Remove two 7.1 mm screws on the small area that stick out from the surface with the JIS #1 screwdriver

Use an extension with the JIS #1 screwdriver in order to get to the screws with yellow marks because they locate deep inside the holes.

1024

Step 2

• Remove the black case to access the circuit board.
• Remove two 4.8mm screws on the circuit board with the JIS #1 screwdriver.

Remove the black case to access the circuit board.

Remove two 4.8mm screws on the circuit board with the JIS #1 screwdriver.

Step 3

• Gently lift up the circuit board from the black case.
• Use a soldering iron to melt the red wire while at the same time pulling it from the motherboard.
• For more information on how to solder and desolder connections, please visit this guide.
• Repeat the previous procedure with the black wire.
• Gently remove the circuit board away from the case.

Gently lift up the circuit board from the black case.

Use a soldering iron to melt the red wire while at the same time pulling it from the motherboard.

For more information on how to solder and desolder connections, please visit this guide.

Repeat the previous procedure with the black wire.

Gently remove the circuit board away from the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Edgar Lopez-Allende                     

Member since: 10/20/2017

207 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UW Tacoma, Team S1-G6, Rose Fall 2017                        

                                                  Member of UW Tacoma, Team S1-G6, Rose Fall 2017 



                    UWT-ROSE-F17S1G6                     


                                            4 Members                     


                                            5 Guides authored