Difficulty

Moderate

Steps

6

Time Required

                          5 minutes

Sections

3

  • Handstrap
  • 2 steps
  • Battery
  • 1 step
  • Casing
  • 3 steps

Flags

0

  • BackCanon Vixia HF R600

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Handstrap
  • Pull up the Velcro strap starting from the front of the camera and working your way towards the back.
  • If you are adjusting the hand-strap, tighten or loosen the Velcro strap accordingly and reattach it.
  • To remove the hand-strap, pull the Velcro strip through the leather pad.

Pull up the Velcro strap starting from the front of the camera and working your way towards the back.

If you are adjusting the hand-strap, tighten or loosen the Velcro strap accordingly and reattach it.

To remove the hand-strap, pull the Velcro strip through the leather pad.

1024

Step 2

  • Remove the strap from the camera body.

Remove the strap from the camera body.

Step 3

              Battery
  • Press in the battery release tab located on the bottom of the camera.
  • Slide the battery out from the body.

Press in the battery release tab located on the bottom of the camera.

Slide the battery out from the body.

Step 4

              Casing
  • Start by removing the two 6mm Phillips #00 screws located on the right side of the camera.
  • Remove four more 6mm Phillips #00 screws found on the bottom of the camera.

Start by removing the two 6mm Phillips #00 screws located on the right side of the camera.

Remove four more 6mm Phillips #00 screws found on the bottom of the camera.

Step 5

  • Open the display screen and remove the three 5mm Phillips #00 screws.
  • Look to the swivel point for the screen to find the last two 5mm Phillips #00 screws that must be removed.

Open the display screen and remove the three 5mm Phillips #00 screws.

Look to the swivel point for the screen to find the last two 5mm Phillips #00 screws that must be removed.

Step 6

  • Gently pull the plastic casing away from the camera.

Gently pull the plastic casing away from the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Logan Coats

Member since: 02/10/2016

522 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 14-4, Lacy Spring 2016                        

                                                  Member of USF Tampa, Team 14-4, Lacy Spring 2016 



                    USFT-LACY-S16S14G4                     


                                            3 Members                     


                                            16 Guides authored