Difficulty

Easy

Steps

7

Time Required

                          2 - 4 minutes

Sections

2

  • Disassembling Canon Selphy CP910 Body
  • 4 steps
  • LCD Screen
  • 3 steps

Flags

0

  • BackCanon Selphy CP910

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Contact the manufacturer for inquiries about receiving parts of the Canon Selphy CP910.

What you need

Step 1

              Disassembling Canon Selphy CP910 Body
  • Turn the printer over.
  • Use the PH1 screw bit to remove the three 8 mm screws in the middle of the back plate.
  • Keep track of these screws because you will need them to reassemble the printer.

Turn the printer over.

Use the PH1 screw bit to remove the three 8 mm screws in the middle of the back plate.

Keep track of these screws because you will need them to reassemble the printer.

1024

Step 2

  • Loosen up the four 10 mm corner screws.
  • A screwdriver with a long shaft approximately 7mm in diameter will make it easier to reach these screws.

Loosen up the four 10 mm corner screws.

A screwdriver with a long shaft approximately 7mm in diameter will make it easier to reach these screws.

Step 3

  • Turn the device around and remove the “open” lid.
  • This lid needs to be removed in order to take the printer apart.
  • Gently bend the lid and remove it from its hinges.

Turn the device around and remove the “open” lid.

This lid needs to be removed in order to take the printer apart.

Gently bend the lid and remove it from its hinges.

Step 4

  • Turn the device back over and lift the top panel up.
  • Disconnect the ribbon cables leading to the LCD screen.
  • Pull the top panel off.

Turn the device back over and lift the top panel up.

Disconnect the ribbon cables leading to the LCD screen.

Pull the top panel off.

Step 5

              LCD Screen
  • Once you detach the top, turn the device around.
  • Use the PH0 screw bit to remove the five [size] screws.

Once you detach the top, turn the device around.

Use the PH0 screw bit to remove the five [size] screws.

Step 6

  • Push out the LCD screen from the main case.
  • The screen should slide out freely.

Push out the LCD screen from the main case.

The screen should slide out freely.

Step 7

  • Pull out the rod connecting the LCD screen to the frame.
  • Insert the new screen.

Pull out the rod connecting the LCD screen to the frame.

Insert the new screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Christie Peralta

Member since: 02/01/2016

700 Reputation

                                      5 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       UW Tacoma, Team 1-6, Rose Winter 2016                        

                                                  Member of UW Tacoma, Team 1-6, Rose Winter 2016 



                    UWT-ROSE-W16S1G6                     


                                            4 Members                     


                                            5 Guides authored