Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

1

  • Screen
  • 8 steps

Flags

0

  • BackCanon Selphy CP720

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen
  • Remove the three 6mm Phillips #1 screws.

Remove the three 6mm Phillips #1 screws.

1024

Step 2

  • Remove the four 8mm Phillips #1 screws, located in each corner of the device.

Remove the four 8mm Phillips #1 screws, located in each corner of the device.

Step 3

  • Grasp one half of the device’s shell in each hand, and pull them apart. They are connected, so don’t separate them completely.

Grasp one half of the device’s shell in each hand, and pull them apart. They are connected, so don’t separate them completely.

Step 4

  • Lift the side panel off to expose the inside of the printer.

Lift the side panel off to expose the inside of the printer.

Step 5

  • Remove the four 8mm Phillips #00 screws that hold the upper circuit board to the shell.

Remove the four 8mm Phillips #00 screws that hold the upper circuit board to the shell.

Step 6

  • Remove two 8mm Phillips #00 screws from the yellow board.

Remove two 8mm Phillips #00 screws from the yellow board.

Step 7

  • Remove the two 8mm Phillips #00 screws from the screen.
  • Lift off the circuit board, yellow board, and screen.

Remove the two 8mm Phillips #00 screws from the screen.

Lift off the circuit board, yellow board, and screen.

Step 8

  • To separate the screen from the circuit board, grasp the data ribbon cable near the base of the black connector on the circuit board and pull parallel to the surface of the board, toward the screen.

To separate the screen from the circuit board, grasp the data ribbon cable near the base of the black connector on the circuit board and pull parallel to the surface of the board, toward the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Peter Ely

Member since: 09/26/2018

812 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Eastern Washington University, Team S1-G1, Carnegie Fall 2018                        

                                                  Member of Eastern Washington University, Team S1-G1, Carnegie Fall 2018 



                    EWU-CARNEGIE-F18S1G1                     


                                            4 Members                     


                                            5 Guides authored