Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
1
- Cooling Fan
- 5 steps
Flags
0
BackCanon Selphy CP720
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Cooling Fan
- Remove the four 8mm Phillips #1 screws from the bottom of the printer.
Remove the four 8mm Phillips #1 screws from the bottom of the printer.
1024
Step 2
- Gently lift the top half of the printer off its base
- A data ribbon attaches the two halves, so don’t pull hard and keep the two halves close together.
Gently lift the top half of the printer off its base
A data ribbon attaches the two halves, so don’t pull hard and keep the two halves close together.
Step 3
- Remove the side panel by lifting it out.
Remove the side panel by lifting it out.
Step 4
- Unplug the fan from the circuit board by gently pulling on the wire connector at the base of the port.
- Do not tug on the wires. Slowly increasing force as you pull is the best way to detach the wires.
Unplug the fan from the circuit board by gently pulling on the wire connector at the base of the port.
Do not tug on the wires. Slowly increasing force as you pull is the best way to detach the wires.
Step 5
- Unscrew the two 8mm Phillips #1 screws from the fan.
- Remove the fan from the panel.
Unscrew the two 8mm Phillips #1 screws from the fan.
Remove the fan from the panel.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Peter Ely
Member since: 09/26/2018
812 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Eastern Washington University, Team S1-G1, Carnegie Fall 2018
Member of Eastern Washington University, Team S1-G1, Carnegie Fall 2018
EWU-CARNEGIE-F18S1G1
4 Members
5 Guides authored
