Canon Powershot Sx600 Hs Power And Shutter Buttons Replacement Repair Guide

Difficulty

Easy

Steps

8

Time Required

                          1 - 5 minutes            

Sections

2

• Battery
• 3 steps
• Power and Shutter Buttons
• 5 steps

Flags

0

• BackCanon PowerShot SX600 HS

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• To remove the battery, locate the battery cover on the bottom of the camera.
• Using your thumb, press down on the cover and slide it outwards.

To remove the battery, locate the battery cover on the bottom of the camera.

Using your thumb, press down on the cover and slide it outwards.

1024

Step 2

• Depress the orange lever holding the battery in place to unlock it.

Depress the orange lever holding the battery in place to unlock it.

Step 3

• Use your fingers to remove the battery.
• Be sure to remember the alignment of the nodes for reassembly.

Use your fingers to remove the battery.

Be sure to remember the alignment of the nodes for reassembly.

Step 4

              Power and Shutter Buttons               

• Use a #000 Phillips screwdriver to unscrew the four 4mm screws located on the sides of the camera (2 for each side).

Use a #000 Phillips screwdriver to unscrew the four 4mm screws located on the sides of the camera (2 for each side).

Step 5

• Unscrew the four 2mm located on the bottom of the camera using a Phillips #000 screwdriver.

Unscrew the four 2mm located on the bottom of the camera using a Phillips #000 screwdriver.

Step 6

• Use a plastic opening tool to loosen and remove both the front and back plates of the camera, as well as the two side pieces.

Use a plastic opening tool to loosen and remove both the front and back plates of the camera, as well as the two side pieces.

Step 7

• Unscrew the three 2mm screws attaching the piece to the camera frame with a #000 Phillips screwdriver.

Unscrew the three 2mm screws attaching the piece to the camera frame with a #000 Phillips screwdriver.

Step 8

• Use an opening tool to gently remove the power and shutter button assembly from the frame.

Use an opening tool to gently remove the power and shutter button assembly from the frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Jennyfer Munoz                     

Member since: 02/15/2017

411 Reputation

                                      3 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges                           

Team

                       USF Tampa, Team S6-G4, Lacy Spring 2017                        

                                                  Member of USF Tampa, Team S6-G4, Lacy Spring 2017 



                    USFT-LACY-S17S6G4                     


                                            3 Members                     


                                            9 Guides authored                     

Evelyn Vose - Jan 6, 2018

Reply

Where does one buy an “opening tool”?

Where does one buy an “opening tool?”

John Maier - Jan 8, 2018

Reply

Hello Evelyn,

you can buy it in the ifixit store. Otherwise you can use a plastic card you don’t need any more (it will be scratched and or bend afterwards, so you probably better don take a creditcard).