Canon Powershot Sx60 Hs Back Panel Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Back Panel
4 steps

Flags

BackCanon PowerShot SX60 HS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

The back panel protects the internal components and sensitive electronics in the device from the elements and minor damages.

What you need

Step 1

              Back Panel

Make sure to power off the device before completing any more steps.
Remove the battery by releasing the orange clip in the battery compartment.

Make sure to power off the device before completing any more steps.

Remove the battery by releasing the orange clip in the battery compartment.

1024

Step 2

Remove the rubber eye piece by pulling it back.
Use the Phillips #00 screwdriver to remove the two 5mm #00 screws located on the side of the viewfinder.

Remove the rubber eye piece by pulling it back.

Use the Phillips #00 screwdriver to remove the two 5mm #00 screws located on the side of the viewfinder.

Step 3

Use the Phillips #00 screwdriver to remove the 4mm #00 screw located on the bottom left of the device.
Use the Phillips #00 screwdriver to remove the 5mm #00 screw located on the bottom center of the device.
Use the Phillips #00 screwdriver to remove the 7mm #00 screw on the right top corner of the camera, just above the media ports.
Use the Phillips #00 screwdriver to remove the two 5mm #00 screws located on the right side, under the media port dust cover.

Use the Phillips #00 screwdriver to remove the 4mm #00 screw located on the bottom left of the device.

Use the Phillips #00 screwdriver to remove the 5mm #00 screw located on the bottom center of the device.

Use the Phillips #00 screwdriver to remove the 7mm #00 screw on the right top corner of the camera, just above the media ports.

Use the Phillips #00 screwdriver to remove the two 5mm #00 screws located on the right side, under the media port dust cover.

Step 4

Ensure the LCD screen is swung fully to the left before taking off the back panel.
Use the iFixit opening tool to pry off the back panel.
Don’t completely pull off the back panel because there is still a ribbon attached.
Use the black spudger to unclip the ribbon located behind the battery compartment. Then remove it using the nylon tipped tweezers.
Once the ribbon is unplugged, remove the back panel from the camera body.

Ensure the LCD screen is swung fully to the left before taking off the back panel.

Use the iFixit opening tool to pry off the back panel.

Don’t completely pull off the back panel because there is still a ribbon attached.

Use the black spudger to unclip the ribbon located behind the battery compartment. Then remove it using the nylon tipped tweezers.

Once the ribbon is unplugged, remove the back panel from the camera body.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Ethan Boone

Member since: 07/08/2019

803 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Embry-Riddle Aeronautical University, Team S3-G7, Watkins Summer 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G7, Watkins Summer 2019 



                    ERAU-WATKINS-SU19S3G7                     


                                            4 Members                     


                                            8 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team