Canon Powershot Sx520 Hs Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          5 - 10 minutes            

Sections

3

• Battery
• 2 steps
• Back Face
• 4 steps
• LCD Screen
• 2 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

• BackCanon PowerShot SX520 HS

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Using your fingers, slide the battery compartment door to the right until it unlocks.

Using your fingers, slide the battery compartment door to the right until it unlocks.

1024

Step 2

• Rotate the door along hinges to open.
• Take out the battery with your fingers.

Rotate the door along hinges to open.

Take out the battery with your fingers.

Step 3

              Back Face               

• Remove 2-3.4 mm screws that secure the back panel using a Phillips #000 screwdriver.
• Remove 4-4 mm screws on the left and right sides of the camera using a Phillips #000 screwdriver.

Remove 2-3.4 mm screws that secure the back panel using a Phillips #000 screwdriver.

Remove 4-4 mm screws on the left and right sides of the camera using a Phillips #000 screwdriver.

Step 4

• Remove 2-4 mm screws that secure the bottom of the camera using a Phillips #000 screwdriver.

Remove 2-4 mm screws that secure the bottom of the camera using a Phillips #000 screwdriver.

Step 5

• Pull back the rubber facing to access the A/V and HDMI output compartment.
• Remove 1-3.4mm screw inside the compartment using a Phillips #000 screwdriver.

Pull back the rubber facing to access the A/V and HDMI output compartment.

Remove 1-3.4mm screw inside the compartment using a Phillips #000 screwdriver.

Step 6

• Once all screws are removed, pull the back facing off with your fingers.

Once all screws are removed, pull the back facing off with your fingers.

Step 7

              LCD Screen               

• Remove 3-4.4 mm screws that secure the small metal plate using a Phillips #000 screwdriver.

Remove 3-4.4 mm screws that secure the small metal plate using a Phillips #000 screwdriver.

Step 8

• Carefully pop out the LCD screen with your fingers.

Carefully pop out the LCD screen with your fingers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Lisa Choe                     

Member since: 09/22/2015

460 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Baylor, Team 4-4, Williams Fall 2015                        

                                                  Member of Baylor, Team 4-4, Williams Fall 2015 



                    BU-WILLIAMS-F15S4G4                     


                                            4 Members                     


                                            6 Guides authored