Difficulty

Moderate

Steps

12

Time Required

                          9 minutes

Sections

3

  • Battery
  • 3 steps
  • Back Cover
  • 5 steps
  • Control Dial
  • 4 steps

Flags

0

  • BackCanon PowerShot SX500 IS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Rotate the camera to expose the underside of the camera.

Rotate the camera to expose the underside of the camera.

1024

Step 2

  • Slide the rounded rectangle tab to the left to release the battery cover.

Slide the rounded rectangle tab to the left to release the battery cover.

Step 3

  • Push the small orange tab forward to release the battery (Battery is ready for removal).

Push the small orange tab forward to release the battery (Battery is ready for removal).

Step 4

              Back Cover
  • Using the Phillips 00 screwdriver, remove the two 4mm top screws above the LCD screen.

Using the Phillips 00 screwdriver, remove the two 4mm top screws above the LCD screen.

Step 5

  • Using the Phillips 00 screwdriver, remove the two 4mm side screws to the left of the LCD screen.

Using the Phillips 00 screwdriver, remove the two 4mm side screws to the left of the LCD screen.

Step 6

Step 7

  • Using the Phillips 00 screwdriver, remove the three 4mm screws from the underside of the camera.

Using the Phillips 00 screwdriver, remove the three 4mm screws from the underside of the camera.

Step 8

  • Using the plastic pry tool, remove the back cover from camera.

Using the plastic pry tool, remove the back cover from camera.

Step 9

              Control Dial
  • Using the Phillips 00 screwdriver, remove the two 3mm screws closest to the right of the LCD screen.

Using the Phillips 00 screwdriver, remove the two 3mm screws closest to the right of the LCD screen.

Step 10

  • Using the Phiillips 00 screwdriver, remove the 4mm screw to the right of the control dial.

Using the Phiillips 00 screwdriver, remove the 4mm screw to the right of the control dial.

Step 11

  • Using the spudger, lift the control dial to the right of the LCD screen.

Using the spudger, lift the control dial to the right of the LCD screen.

Step 12

  • Using the spudger, lift the connection tab and remove the control dial’s orange ribbon from motherboard.

Using the spudger, lift the connection tab and remove the control dial’s orange ribbon from motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Shelby Spiering

Member since: 04/07/2015

243 Reputation

                                      1 Guide authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Eastern Washington University, Team 1-4, Plummer Spring 2015                        

                                                  Member of Eastern Washington University, Team 1-4, Plummer Spring 2015 



                    EWU-PLUMMER-S15S1G4                     


                                            4 Members                     


                                            6 Guides authored

edgarlugo20111917 - Apr 17, 2016

Reply

Gracias gracias gracias