Canon Powershot Sx30 Is Lcd Panel Front Cover Replacement Repair Guide

Difficulty

Easy

Steps

7

Time Required

                          10 minutes            

Sections

2

• LCD Panel Rear Cover
• 5 steps
• LCD Panel Front Cover
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackCanon Powershot SX30 IS

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              LCD Panel Rear Cover               

• Turn the camera so the back of it is facing you.
• Pull the LCD screen towards you in order to open it,

Turn the camera so the back of it is facing you.

Pull the LCD screen towards you in order to open it,

1024

Step 2

• Unscrew the two 3 mm screws shown on the left side of the LCD screen panel using a Phillips screwdriver.

Unscrew the two 3 mm screws shown on the left side of the LCD screen panel using a Phillips screwdriver.

Step 3

• Unscrew the two 3 mm screws shown on the right side of the LCD screen panel.

Unscrew the two 3 mm screws shown on the right side of the LCD screen panel.

Step 4

• Using the plastic opening tool, remove the rear case of the front LCD cover.

Using the plastic opening tool, remove the rear case of the front LCD cover.

Step 5

• Pull off the back panel of the LCD screen and the plastic wire protector. Then replace the back panel.

Pull off the back panel of the LCD screen and the plastic wire protector. Then replace the back panel.

Step 6

              LCD Panel Front Cover               

• Unscrew the 2mm screw on the outer edge of the panel

Unscrew the 2mm screw on the outer edge of the panel

Step 7

• Unscrew the 3mm screw on the inner edge of the panel. This is easily done by rotating the screen to be perpendicular to the body of the camera, but be careful not to damage the wires or the circuit board.
• The panel will fall right off

Unscrew the 3mm screw on the inner edge of the panel. This is easily done by rotating the screen to be perpendicular to the body of the camera, but be careful not to damage the wires or the circuit board.

The panel will fall right off

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Ellis DeVoe                     

Member since: 04/14/2015

574 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 5-12, Maness Spring 2015                        

                                                  Member of Cal Poly, Team 5-12, Maness Spring 2015 



                    CPSU-MANESS-S15S5G12                     


                                            4 Members                     


                                            5 Guides authored