Canon Powershot Sx30 Is Back Camera Housing Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          15 - 30 minutes            

Sections

1

• Back Camera Housing
• 9 steps

Flags

0

• BackCanon Powershot SX30 IS

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Camera Housing               

• Position the camera so that the right side is visible as shown.
• Unscrew the two 6 mm screws shown using a screwdriver.

Position the camera so that the right side is visible as shown.

Unscrew the two 6 mm screws shown using a screwdriver.

1024

Step 2

• Remove the plastic flap by pressing down on the center of the hinge and pulling on the flap with the spudger.
• Then, unscrew the lone 6mm screw that was under the plastic flap.

Remove the plastic flap by pressing down on the center of the hinge and pulling on the flap with the spudger.

Then, unscrew the lone 6mm screw that was under the plastic flap.

Step 3

• Turn the camera so that the bottom is visible, as shown.
• Unscrew the three 4mm screws shown red using a screwdriver.
• Unscrew the single 6mm screw.
• Do not touch the screw shown yellow, removal is unnecessary. (Note: the top right yellow screw should be removed)

Turn the camera so that the bottom is visible, as shown.

Unscrew the three 4mm screws shown red using a screwdriver.

Unscrew the single 6mm screw.

Do not touch the screw shown yellow, removal is unnecessary. (Note: the top right yellow screw should be removed)

Step 4

• Turn the camera so the back side is visible, as shown.
• Unscrew the two 6mm screws.

Turn the camera so the back side is visible, as shown.

Unscrew the two 6mm screws.

Step 5

• Gently remove the back cover using the spudger.
• Exercise caution, as the wire inside is fragile.

Gently remove the back cover using the spudger.

Exercise caution, as the wire inside is fragile.

Step 6

• Detach the wire by lifting the small black bar that holds it to the main body of the camera.

Detach the wire by lifting the small black bar that holds it to the main body of the camera.

Step 7

• Attach the new cover onto the camera.

Attach the new cover onto the camera.

Step 8

• Reattach the wire to your new rear casing.

Reattach the wire to your new rear casing.

Step 9

• Close the back cover, and re-insert appropriate screws.

Close the back cover, and re-insert appropriate screws.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 10 other contributors 

                    Ellis DeVoe                     

Member since: 04/14/2015

574 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 5-12, Maness Spring 2015                        

                                                  Member of Cal Poly, Team 5-12, Maness Spring 2015 



                    CPSU-MANESS-S15S5G12                     


                                            4 Members                     


                                            5 Guides authored